img
 
 
®
®
Monarch
®
®
1103 -1110
Labelers
Operating Instructions
LOADING LABELS & SETTING PRINT BANDS
©2001 Paxar Corporation. All rights reserved.
Printed in U.S.A.
LOADING LABELS
1
2
If labeler has label guide: Snap
If labeler has no label guide: Snap
Squeeze and hold
label roll between hubs. Tear off
label roll between hubs. Tear off
operating lever half way,
and discard first twelve labels and
and discard first twelve labels and
and feed label strip under brake
backing paper. Then, insert label
backing paper.
wheels.
Brake
strip into guide slot as shown.
Wheels
Guide Slot
Label Guide
Operating
Lever
3
4
5
Continue feeding label
a. Feed label strip up under
Grasp label strip and pull
strip until about twelve
plate until two labels come
briskly toward operating
labels come out here. Release
out here.
lever,
operating lever.
separating
labels
from
backing
Plate
paper.
b. Squeeze operating
Loop
Discard
lever halfway and
separated
rewind label roll until
labels.
loop is removed.
6
7
8
Tear backing paper as
Completely squeeze operating
Squeeze operating lever
shown.
lever, exposing feedwheel.
several times until backing
Insert backing paper into slot. When
paper exits labeler. If backing
paper bows up, maintain finger
paper does not become taut and
pressure and release operating lever.
exit at rear, remove backing
paper from slot and repeat steps
6 and 7.
Slot
Backing paper
without labels
Straight tear
Feedwheel
between I-cuts
SETTING PRINT BANDS
1
2
3
Pull knob until indicators point to
Turn knob until indicators point
Set all bands and push
desired band.
to desired character or blank.
knob in all the way.
Make sure the character you
n
select is not a print character
(UPSIDE DOWN). You
should be able to read the
character correctly through
Indicators
the band window.
INKING
1
2
3
Turn latch to release ink roll
Fold a piece of scrap backing
Insert folded backing paper
door and carefully pull it
paper.
between ink roll and carrier.
completely out of labeler.
Pull to snap old ink roll free.
Latch
Ink Roll Door
4
5
6
Cut off end of new ink roll
Insert ink roll into ink door
Latch ink roll door securely.
pouch. Using pouch to protect
opening. Tilt ink door and
fingers, slide carrier into pouch and
press in . . .
snap new ink roll into carrier (one side
at a time).
Lip
to place
hinge tab
under lip.
INKING

                                                Back to StoreSupplies.com               Main Questions and Answers               Next Page